Light/Meters/Switches Contents; Light/Meters/Switches Service Information - Honda Motorcycle Service Manual

SERVICE INFORMATION
25-1 LOW FUEL INDICATOR 25-8
OIL PRESSURE WARNING LIGHT FUEL PUMP 25-9
(4-STROKE ENGINE)
25-2 HEADLIGHT BULB 25-1 1
OIL LEVEL INDICATOR
(2-STROKE ENGINE) 25-2
SWITCHES 25-1 2
FAN MOTOR SWITCH 25-4
TURN SIGNAL LIGHTS 25-1 6
COOLANT TEMPERATURE GAUGE 25-5
HORN 25-1 7
FUEL GAUGE 25-7
SIDE STAND SWITCH 25-1 8
SIDE STAND INDICATOR 25-19
SERVICE INFORMATION
-
while the headlight is ON, and remain hot for a while after they are turned
OFF. Be sure to let them cool down before servicing.
-.
Use an electric heating element to heat the waterlcoolant mixture for thermo sensor inspection
. .
- -
terials a w a y from the electmic heating element. Wear
R V R
Drotectlon.
Refer to section 21 for general service rules for electrical components.
This section covers general inspectioniservice procedures for fights, meters and switches. Refer to the model Specific
manual for the location and arrangement of components on the model being sarviced.
Note the following when replacing the halogen headlight bulb:
- Wear clean gloves while replacing the bulb. Do not put finger prints on the headlight bulb, as they may create hot spots
on the bulb and cause it to break.
- If you touch the bulb with your bare hands, clean it with a cloth moistened with alcohol to prevent its early failure.
-
Be sure to install the dust cover after replacing the bulb.
A continuity test can be made with the switches installed on the motorcycle.
-
Check the battery condition before performing any inspection that requires proper battery voltage.
There are two types of lighting systems: AC lighting that takes power from the alternator coil,and DC lighting that takes
power from the battery.
On
DC lighting systems, the headlight comes on without starting the engine. On AC lighting
systems, the headlight comes on when the engine starts. (Refer to section 21).
Date of Issue: March.
1995
0
HONDA MOTOR CO.,LTD