Air Cleaner Case Removal; Air Cleaner Case Installation - Honda XL200 2001 Shop Manual

XL2 0 0
5. Turn the pilot screw 1/2 turn out from the initial setting.
6. If the engine speed increases by 50 min
the pilot screw out by continual 1/2 turn increments until
engine speed does not increase.
7. Adjust the idle speed with the throttle stop screw.
8. Turn the pilot screw in until the engine speed drops 50 min
(rpm).
9.Turn the pilot screw 1/2 turn in from the position obtain step 8.
10. Adjust the idle speed with the throttle stop screw.
AIR CLEANER CASE
REMOVAL
Remove the following:
– Seat
– Both side covers
– Battery
– Starter relay switch
– Muffler
Loosen the air connecting tube band screw.
Remove the bolts and regulator/rectifier unit.
Remove the air cleaner case mounting bolts.
Pull the air cleaner case backward, then remove the case.
INSTALLATION
Installation is in the reverse order of removal.
-1 ( rpm) or more, turn
-1
PILOT SCREW
FUEL SYSTEM
4 -1 5