V-MATIC BELT DRlVE SYSTEM
Remove the pulley assembly once with the drive belt installed.
NOTE
/
.
Hold the pulley faces apart preventing them from
closing.
I
Put the drive belt over the drive pulley
Reinstall the driven pulley on the drive shaft with the drive belt
attached.
Install the clutch outer and the universal holder. Tighten the
nut to the specified torque.
a
UNIVERSAL HOLDER
0 7 7 2 5 - 0 0 3 0 0 0 0
Reinstall the left crankcase cover (see Model Specific manual)
DRIVE PULLEY
REMOVAL
DRIVE PULLEY
Remove the left crankcase cover (see Model Specific manuall.
Hold the drive pulley face using the drive pulley holder and
remove the nut and washer.
Remove the drive pulley face
m
DRIVE PULLEY HOLDER
07923-KM10000
If the drive pulley holder cannot be used, remove the cooling
fan at the right side of the crankshaft, and hold the flywheel
with the universal holder.
m
UNIVERSAL HOLDER
07725-0030000
NUT
DRIVE PULLEY
E z l
/ I
\
UNIVERSAL
HOLD
Date of Issue: Sep.,
1988
12-6
o
HoNDA MOTOR CO., LTD.