Honda Motorcycle Service Manual page 52

MAINTENANCE
Install the drive chain cutter and stake the ends of the master
link pins.
rn
Drive chain cuttel
NOTE
To prevent over staking, stake gradually checking the
diameter of the staked area using a slide calipers.
After staking, check the staked area of the master link using
a slide calipers.
Diameter of the staked area: Refer t o the Model Specific
service manual.
NOTE
.
When the measured staked area is over the prescribed
value, restake using the new master link, plate and 0 -
rings.
.
When the measured staked area is below the prescribed
value, reinstall the drive chain cutter and restake.
Check the staked area of the master link for cracks and the O-
rings for damages.
If there is any cracking or damage, replace the master link.
plate and O-rings.
Check that master link pivots freely on the pins.
If the movement is not smooth, restake using the new master
link, plate and O-rings.
Adjust the drive chain play
I
MASTER LINK
qHp
DRIVE CHAIN CUTTER
SLIDE CALIPER
I
Date of issue : March, 1995
2-26
O
HONDA MOTOR CO.,LTD.