Camber/Caster - Honda Motorcycle Service Manual

MAINTENANCE
Measure the toe-in on the rear part of the tires at the same
points.
When the toe-in is out of specification, adjust it by changing
the length of the tie-rods equally while measuring the toe-in.
Remove the wheel cap, cotter pin and front axle nut.
Install an attachment onto the front axle.
Put the camber and caster gauge onto the attachment
Measure the camber.
Set the turn gauge under the front wheels.
Measure the caster.
Camber and caster are not adjustable. If they are out of
specificat~on, check the suspension and frame for damage and
replace any parts necessary, then recheck alignment.
Date of Issue: March.1995
2-44
o
HONDA MOTOR CO.,LTD.