Race Replacement; Top Race Removal - Honda Motorcycle Service Manual

FRONT SUSPENSION
RACE REPLACEMENT
Bearings should be replaced as a set-inner and outer
If the motorcycle has been involved in an accident, ex-
amine the area around the steering head for cracks.
Remove the races from the steering head using the ball race
remover.
Refer to the Model Specific manual for specific information
about tools.
Install new races into the steering head using the driver and
attachment.
NOTE
.
Drive the races in squarely, making sure that they are ful-
ly seated.
1
I
= B A I L RACE
REMOVER
BALL RACE
REMOVER
I
On aluminum frames: replace the races using the Ball Race
Remover Set as described in the following procedure.
Ball race remover set (includes (1) thru. (61)
07946-KM90001
(1) Driver shaft 07946-KM90300
(2) Base 07946-KM90600
(3) Attachment A, 4 7 mm 07946-KM90100
(4) Attachment 6, 5 5 mm 07946-KM90200
(5) Remover A, 4 7 mm 07946-KM90401
(6) Remover B, 5 5 mm 07946-KM90500
Top Race Removal
Install remover tool A into the steering head and place attach-
I
DRIVER ATTACHMENT A, 47 mm
ment A onto remover A and secure
it
with nut B.
lnstall attachment B onto the Driver shaft and install them
through attachment A.
lnstall the base noting the proper installing direction and screw
in nut A.
Set attachment B into the bottom of the steering head.
Hold the driver shaft with a wrench and tighten nut A to
remove the upper race.
ATTACHMENT
B. 55 mm
Date of Issue: March,
1995
o
HONDA MOTOR CO.,LTD.
18-17