Honda Motorcycle Service Manual page 189

lnstall the clutch damper springs.
lnstall the clutch assembly onto the crankshaft
Install the collar and clutch center guide onto the crankshaft.
lnstall the primary driven gear onto the mainshaft and secure it
with a snap ring.
lnstall a new lock washer B (tongued washer) onto the
mainshaft.
PRIMARY DRIVEN
COLLAR
GEAR
SNAP RING CENTER GUIDE
NOTE
Replace lock washer B with new one whenever it is
removed.
lnstall lock washer A with the "OUTSIDE" mark facing out-
side. If there is no mark, install the lock washer with the con-
vex side toward the outside.
lnstall the lock nut with the chamfered edge toward the inside.
/
"OUT SIDE" MARK
I
Hold the clutch outer using a special holder tool and tighten
the lock nut to the specified torque.
Bend the tab of lock washer B up into the lock nut groove.
NOTE
If the tab and groove aren't aligned, turn the lock nut in
the tightening direction t o align; do not loosen the nut to
set the locking tab.
Date of Issue: Sep., 1988
@
HONDA MOTOR CO., LTD.