Clutch Slave Cylinder; Clutch Slave Cylinder Assembly - Honda Motorcycle Service Manual

CLUTCH
Disassemble the slave cylinder and replace the piston seal as
required.
Place a clean pan under the slave cylinder t o catch the draining
fluid and squeeze the clutch lever slowly t o push out the
piston.
Drain the clutch fluid. Temporarily install the slave cylinder
then disconnect the clutch hose.
CLUTCH SLAVE CYLINDER
Place a rag over painted, plastic or rubber parts whenever the
system is serviced.
CAUTION
Spilled fluid will damage painted, plastic, or rubber parts.
Remove the slave cylinder mounting bolts and then remove the
slave cylinder from the crankcase.
NOTE
Remove the spring from the piston.
Check the piston and cylinder for scoring or scratches.
Remove the oil seal and piston seal from the piston and discard
them.
The seals must be replaced with new ones whenever they
have been removed.
SLAVE CYLINDER
HOSE BOLT
Assembly
Assemble the slave cylinder in the reverse order of
disassembly.
Apply a medium grade of hi-temperature silicone grease or
brake fluid to the new piston seal and oil seal.
been removed.
Inspect the piston seals for signs of leakage.
Carefully seat the piston seal in the piston groove. Install the
oil seal. Place the piston in the cylinder w i t h the seal end facing
out.
Install the spring in the cylinder with small end toward the
piston.
OIL SEAL
SEAL
PISTON SEAL
I
SLAVE CYLINDER
OIL SEAL BODY
1
Date of Issue: Sep., 1988
O HONDA MOTOR CO., LTD.
11-31