Honda Motorcycle Service Manual page 184

CLUTCH
Install the pressure plate, discs, plates and clutch center onto
the mainshaft i n the order shown. If a judder spring is used, in-
stall the judder spring and spring seat as shown below.
Coat the clutch discs and plates with clean oil.
DISCS AND PLATES
PRESSURE PLATE CLUTCH
I
CENTER
larger I.D. than the other discs.
If the splines of the clutch center cannot be aligned with
the mainshaft splines while installing, change the
transmission into any gear position and turn the rear
wheel t o ease installation.
Make sure that the clutch center is installed completely; the
grooves of the clutch center must align with the tabs of the
pressure plates.
If the clutch is secured with a lock nut:
Install the lock washer onto the mainshaft w i t h the
"OUTSIDE" mark facing outside.
If there is no mark, install the lock washer with the convex side
facing out
Install the lock nut and tighten it t o the specified torque.
NOTE
.
Use a new lock nut if the lock nut was staked.
Face the chamfered side of the lock nut inward if the
lock nut is chamfered.
.
If a snap ring is used:
Set the snap ring into the groove in the mainshaft w i t h the
chamfered side inward. Turn the snap ring t o be sure that it is
seated i n the groove.
DISC
I
SPRING JUDDER
SPRING
CLUTCH CEPTER PR/ESSURE PLATE
Date of Issue: Nov., 1989
O
HONDA MOTOR CO., LTD.