Honda Motorcycle Service Manual page 302

FRONT SUSPENSION
Pull the fork tube out of the fork slider
NOTE
If the type of fork being disassembled has a guide
bushing installed, remove the fork tube as follows:
Pull the fork tube out until resistance from the slider bushing is
felt. Then move it in and out, tapping the bushing lightly until
the fork tube separates from the slider. The slider bushing will
be forced out by the fork tube bushing.
Remove the following:
.
Oil seal.
.
Back-up ring.
.
Fork tube bushing.
-
Guide bushing, if installed.
Rebound spring, if possible.
NOTE
1
.
Do not remove the fork tube bushings unless it is
1
- -
necessary t o replace them with new ones.
NOTE
.
On the fork type that has n o guide bushing, the oil seal
may remain i n the slider after the fork tube is removed.
Remove the oil seal being careful not t o damage the oil
seal seatina surface of the slider.
!
Remove the following:
Oil lock piece from the fork slider.
-
Stop ring from the fork piston.
Clean all disassembled parts.
<ORK TUBE
BACK-UP RING
I
I
1
OIL SEAL
I
F&K
TUBE
GUIDE BUSHING BUSHING
OIL SEAL
FORK SLIDER
18-6
Date of Issue : March. 1995
0
HONDA MOTOR CO.,LTD.