Alternator; Charging (Charging/Lighting) Coil Inspection; Stator Removal - Honda Motorcycle Service Manual

BATTERIESICHARGINGILIGHTING SYSTEM
ALTERNATOR
(A)
CHARGING (CHARGINGILIGHTING) COIL
INSPECTION
NOTE
.
It is not necessary to remove the alternator from the
enaine.
Disconnect the alternator connector and check continuity be-
tween the wires.
(A) For single phase coils whose end is grounded, measure
the resistance between the output line and ground. (If the
measured value is not correct, check for continuity
between the stator ground wire and ground, and between
the alternator cover ground wire and ground.)
(B) For coils with t w o output lines, measure resistance
between the lines. Check that there is no continuity
between engine ground and the output lines.
IC) For single phase, combined chargingllighting coils,
measure the resistance at the charging output line and at
lighting output line.
(D) For three phase coils, measure resistance between each
output line, and check that there is no continuity between
each output line and ground.
If the tested resistance, components show infinite
(m)
replace
the stator.
If measurements are only slightly off the specified value, the
stator may not need to be replaced. Check other areas and
decide if replacement is required.
STATOR REMOVAL
Remove alternator cover. (Oil may spill out.)
Hold the flywheel rotor with a holder and remove rotor bolt.
UNIVERSAL HOLDER 07725-0030000 or
ROTORHOLDER 07725-0040000
CAUTION
Choose the correct holder. Using the wrong tool may
damage components. Refer to the Model Specific
manual for the correct holder.
Date of Issue: March, 1995
o
HONDA MOTOR CO.,LTD.
22-27