Brake Disc Inspection; Master Cylinder Disassembly - Honda Motorcycle Service Manual

BRAKES
BRAKE DlSC INSPECTION
Visually inspect the discs for damage or cracks.
Measure the brake disc thickness at several points and replace
the disc if the smallest measurement is less than the specified
service limit.
Refer to the Model Specific manual for the service limit.
NOTE
The service limit is stamped on some discs.
1
DISC
Check the brake disc for warpage
inspect the wheel bearings for excessive play if the warpage
exceeds the specification. Replace the brake disc if the
wheel bearings are normal.
MASTER CYLINDER
DIAL INDICATOR
Disassembly
CAUTION
DO not allow foreign materials to enter the master
cvlmder.
NOTE
a set whenever thev are disassembled.
Disconnect the wire from the brake light switch.
Drain the brake fluid (page 17-9).
Remove the brake lever from the master cylinder.
Disconnect the brake hose.
Remove the master cylinder holder and the master cylinder.
Remove the rubber boot.
Remove the snap ring.
SNAP RING PLIERS
Remove the piston and spring.
Clean the master cylinder with the recommended brake fluid.
1
BRAKE HOSE MASTER CYLINDER
- -
Date of Issue: March, 1995
O
HONDA MOTOR CO ,LTD