Side Stand Switch Inspection; Side Stand Switch Replacement - Honda Motorcycle Service Manual

SIDE STAND SWITCH
INSPECTION
NOTE
If there is an open circuit or poor connection in the ignition circuit of the side stand switch, the following symptoms
will occur with the side stand retracted.
-
Models with centrifugal clutch: Starter motor will not operate.
-
Models with manual clutch: Starter motor will not operate with the transmission in gear and the clutch disengaged.
(The engine stops when the transmisison is shifted into gear.)
-
Models with kick starter: Engine will not start. (No spark at plug.)
If you suspect the side stand ciucuit, first check the operation of the side stand indicator. If the indicator operation
is normal, the problem is in the side stand circuit.
Disconnect the connector from the ignition control module.
Check for continuity between the side stand switch wire
(ignition side: Green/White) of the harness side connector
and ground.
Side stand retracted: Continuity
Side stand lowered: No continuity
MODULE CONNECTOR-
If there are any faults in above continuity check, disconnect
the side stand switch connector.
Check for continuity between the wire terminals of the switch
side connector.
Side stand
Position
Lowered
NOTE
Retracted
The switch is installed on either the front or the rear of
the side stand Divot , de~endina on the model.
Green1
white
c-
I I
0
Removal
Remove the switch attaching bolt from the side stand pivot.
Disconnect the switch wire connector from the harness and
remove the switch.
NOTE
Do not attempt to disassemble the switch because it is
permanently sealed
Yellowl
black
25
- I 8
Date of Issue: March, 1995
0
HONDA MOTOR CO.,LTD.
Green
0
I
0