Starting Enrichment Thermal Valve Removal; Starting Enrichment Valve (Manual); Throttle Valve (Piston Valve Type) - Honda Motorcycle Service Manual

FUEL SYSTEM
STARTING ENRICHMENT THERMAL VALVE
REMOVAL
Remove the starting enrichment thermal valve cover
Remove the screws and set plate
Remove the starting enrichment thermal valve from the
carburetor bodv.
STARTING ENRICHMENT VALVE (Manual)
Loosen the starting enrichment valve nut and remove the
valve spring and valve.
Check the valve face for scores, scratches or wear and replace
if necessary.
Check the seat at the tip of the valve for stepped wear and
replace if necessary.
If the valve seat is worn or damaged, it will not close the fuel
line of the starting enrichment circuit, resulting in a constantly
rich fuel mixture.
THROTTLE VALVE (Piston valve type)
CAUTION
.
Some carburetorlcables have a one-piece throttle
cablelcarburetor top assembly. Do not try t o remove the
throttle cable from the carburetor too.
Remove the carburetor top and pull the throttle valve out of
the carburetor.
While compressing the spring, disconnect the throttle cable
from the throttle valve.
NOTE
.
If the throttle valve is linked to the cable, refer to the
Model Specific manual for each model for removal1
disassembly steps.
Date of Issue: March.1995
0
HONDA MOTOR CO.,LTD.