Stator Installation; Rotor Installation - Honda Motorcycle Service Manual

BATTERIES/CHARGING/LlGHTlNG SYSTEM
STATOR INSTALLATION
Install the stator in the crankcase cover.
Apply a locking agent t o the bolt (or screw) threads and
tighten them to the specified torque.
CAUTION
I f the stator bolts/screws w o r k loose, they m a y come
Into contact with the rotor and cause damage.
Route the stator wire correctly on the crankcase cover.
NOTE
Route the stator wire so that it will not come into contact
with the rotor.
If there is a wire clamp or clip, secure the wire with it.
Apply sealant to the grommet groove to prevent oil or
water leakage.
ROTOR INSTALLATION
Clean the tapered portion of the crankshaft.
If the rotor is installed over dust or d i n on the taper, the taper
will not make secure contact with the rotor and there will be
excessive force on the woodruff key.
Insert the woodruff key into the key groove in the crankshaft.
Set the rotor groove over the woodruff key and install the
rotor on the crankshaft.
Tighten the rotor bolt (or nut) with your fingers
CAUTION
-
Before installing the rotor. check that no nuts or bolts are
magnetiCally attached to the rotor. Installing the rotor
with anything attached to it could damage the stator
coil.
Hold the flywheel rotor with a holder and tighten the bolt (nut)
to the specified torque.
1
WOODRUFF KEY
I
HOLDER (Use the same holder used
to remove rotor bolt)
Date of Issue: March, 1995
0
HONDA MOTOR CO.,LTD.
22-2