Electrical Fundamentals - Honda Motorcycle Service Manual

ELECTRICAL FUNDAMENTALS
If a fuse blows out, diagnose the cause and repair
it.
E When separating connectors, pull only on the connector
Replace the fuse with one of the correct rating.
housing. Do not pull on the wires.
CORRECT INCORRECT
0
X
Always separate wire connectors with the ignition switch in
the OFF position.
~~f~~~
separating a connector, check whether its locking
Make
sure protectors
'Over
the connectors
mechanism is of the push-in type or pull-up type.
and terminal.
GOOD NO GOOD
- -
~
+czso
+
X
When installing a connector, push it until
it
clicks into place.
For connectors with locks, push the connector in lightly
then unlock the lock. Check that the lock is securely
fastened when reconnected.
GOOD CLICK
properly.
Before connecting connectors, check that the pins are
straight and that all the wire terminals are intact and tight.
If a terminal is corroded, clean
it
thoroughly before
connecting.
o G O O D
X
NO GOOD
NO GOOD
Date of Issue : March, 1995
21
-2
0
HONDA MOTOR CO..LTD.