Honda Motorcycle Service Manual page 176

CLUTCH
I
Remove the lifter rod, push rod, discs and clutch plates.
NOTE
/
.
Some models have a steel ball between the lifter and
push rods.
1
Remove iudder spring and spring seat if they are installed.
PUSH
JUODER SPRING
!
'
I ' \
\
LIFTER ROD
I
If the lock nut is staked to the mainshaft, unstake the lock nut
and remove it.
Remove the lock washer.
Remove the clutch center and clutch outer.
(Type C)
Remove the set ring, lifter plate, iifter rod and bearing
Slowly squeeze the clutch lever immediately after removing
the clutch iifter plate, then tie the lever t o the handlebar.
CAUTION
I
Ambient air can contaminate and may damage the clutch
system.
I
Shift the transmission into top gear and apply the rear brake.
Remove the lock nut.
NOTE
.
If the engine is not in the frame, shift the transmission in-
to too aear and hold the drive sprocket using the univer-
Remove the lock washer, clutch spring set plate, clutch spring
and washers.
SET RING
Date of Issue: Sep.
11-12
O
HONDA MOTOR CO
,
1988
8. .
LTD.