Clutch Shoe Replacement; Driven Face Bearing Inspection - Honda Motorcycle Service Manual

V-MATIC BELT DRIVE SYSTEM
CLUTCH SHOE REPLACEMENT
Driven Face Bearing Inspection
Check the inner bearing oil seal (if installed) for damage;
replace as necessary.
Check the needle bearing for damage or excessive play and
replace as necessary.
Turn the inner race of the outer bearing w i t h your finger.
Check that the bearing turns smoothly and quietly, and that
the bearing outer race fits securely. Replace the bearing if
necessary.
NOTE
.
Some models use t w o ball bearings.
Remove the snap rings and washers, then remove the clutch
shoes and shoe springs from the drive plate.
BEARING
Refer t o page
12-1 3
for bearing replacement.
NOTE
SHOE SPRING
\
,DRIVE PLATE
Some models use one retainer plate instead of three
snap rings.
Check the damper rubbers for damage or deformation; replace
as necessary.
Check the shoe springs for damage or loss of tension.
Apply a small amount of grease on the pivot pins.
CLUTCH
SLOE
SNA; RING
Install new clutch shoes on the pivot pins and push them into
place.
Use a small amount o f grease o n the pivot pin and keep grease
off of the brake shoes. Replace the brake shoes if there is any
grease on them.
CAUTION
DAMPER RUBBER
I
A
Grease or oil damages clutch shoes and can lead to a
I
CLUTCH SHOE
12-12
Date of Issue: Sep., 1988
O
HONDA MOTOR CO.. LTD.