Clutch Reassembly; Clutch Center Guide, Collar; Crankshaft - Honda Motorcycle Service Manual

CLUTCH
Clutch Center Guide, Collar (Type D)
1
Measure the I.D, and/or O.D. of the clutch center guide at
the sliding iurface.
Replace the guide if the service limit is exceeded.
Measure the I.D. andlor height of the collar; replace if the
service limit is exceeded.
Crankshaft (Type D)
Measure the O.D. of the crankshaft at the clutch center guide
sliding surface, replace if the service limit is exceeded.
CLUTCH REASSEMBLY
(Type Al
Install the needle bearing or clutch outer guide onto the
mainshaft.
Install the clutch outer onto the mainshaft.
NOTE
If the pump drive sprocket is installed on the mainshaft,
align the holes of the clutch outer with the pins on the oil
pump drive sprocket.
If the primary drive gear is the anti-backlash type, install
the clutch outer onto the mainshaft while moving the
drive sub gear to align the t w o gear teeth using a
screwdriver. Take care not to damage the gear teeth.
Install the thrust washer (if used).
J
C L ~ T C H
CENTER
GUIDE
NEEDLE BEARING
%
PIN
CLUTCH OUTER
PRIMARY DRIVE GEAR/
Date
of
Issue: March,
1995
o
HONDA MOTOR
CO.,LTD.
11-19