Swingarm; Swingarm Inspection; Pro-Link Suspension Linkage Removal; Pro-Link Suspension Linkage Inspection - Honda Motorcycle Service Manual

REAR SUSPENSION
Refer to the Model Specific manual for swing-arm removal,
disassembly, reassembly and installation.
INSPECTION
Remove the chain slider, chain guide and brake torque rod (if
installed).
If the motorcycle is a shaft-drive type, remove the rubber boot.
Check the removed parts for wear or damage and replace
parts if necessary
Check the center collarldistance collar, if installed, for wear,
scoring or scratches and replace if necessary.
PRO-LINK SUSPENSION LINKAGE
NOTE
~~ ~~~~~~~~~~
Mark installed position codes on the suspension linkage
parts before disassembly. The shock arm and connect-
ing rod often have specific installation directions and
they should be installed properly. They may interfere
with the frame and/or change the vehicle height unless
installed properly.
REMOVAL
SHOCK ARM LOWER MOUNTING BOLT
.
Bolts from the frame side of the connecting rod
Rear shock absorber lower mounting bolts
SHOCK ARM
.
Bolts from the swingarm side of the shock arm
Remove the following:
INSPECTION
MOUNTING BOLT
Check the shock arm and connecting rod for deformation,
cracks or other damage and replace as necessary.
.
Rear wheel
Date of Issue: March.
1995
0
HONDA MOTOR CO..LTD