Step 3D: Set Up Ip Address Of Ctx Winadmin Pc Modem (Windows 2000) - Toshiba Strata CTX Programming Manual

Step 3D: Set up IP Address of CTX WinAdmin PC Modem
(Windows 2000)
This setup is only for direct connection to the Strata CTX or for simple Hub or LAN connections.
Note
For more complex LAN, WAN or Internet connections, refer to
Internet Connections"
1. Setup PC modem settings for CTX WinAdmin. Click Start > Settings > Network and Dial-up
Connection > Make New Connection.
2. Click Next. Select radio button Dial-up to private network and click Next.
3. From the "Select a Device Screen" highlight the modem to be used to make a CTX WinAdmin dial-up
connection and click Next.
4. Do not enter Phone number, then click Next.
The phone number for Dial up is entered when setting up the Profile in Strata CTX WinAdmin. See
Note
"User Management"
5. Select radio button "For all users," then click Next.
6. Use the recommended setting (Enable on-demand dialing) and click Next.
7. Type RemoteCTX1 as the name in
Connection Wizard (shown right), then click
Finish.
8. The Connect RemoteCTX1 screen displays.
Note The User name field on this screen will
automatically be populated.
9. Click on the Properties button of the Connect
RemoteCTX1 screen.
10. The RemoteCTX1 screen displays. Click on
the Networking tab and select Internet
Protocol (TCP/IP) in the Components
checked are used by this connection box.
Then click Properties button.
11. The Internet Protocol (TCP/IP) Properties
screen displays. Select "Use the following IP Address" and enter
the IP address (192.168.255.x, where x can be 1~252. It cannot
be 253 or above. It cannot be the same as the CTX IP address in
Program 916 for CTX NIC Connections). This IP address is the
static IP address for the PC when using this modem connection.
Click OK.
12. The initial setup screen displays. Click Properties.
13. Click the Options tab and set up options to the recommended
settings (shown right).
Set "Idle time before hanging up" to more than one minute if
Note
you are transferring CTX WinAdmin calls to the CTX built-
in modem versus direct calls to the modem.
14. The initial setup screen displays, click Ok and exit.
15. Go to Step 3C: Verify Modem Hardware
16. Go to "Establish Communication with Strata CTX"
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
on page 3-5.
on page 3-16.
Settings.
Step 3: Set up Modem Connection
"Wide Area Networks and/or
on page 3-14.
Installation
3-13