Toshiba Strata CTX Programming Manual page 159

F
IELD
19 Bearer Svc Multirate
Unrestricted
20 B Ch Selection Method
21 B-Ch Selection
22 T1 Time Slot Pattern
23 E1 Time Slot Pattern
24 T-Wait Timer
25 RBT on Incoming Call
26 Network Mode
27 Negotiation Priority
29 2-B channel Transfer
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
D
ESCRIPTION
The Bearer Capabilities 384k Unrestricted (H0), 1536k Unrestricted (H11), 1920k
Unrestricted, Restricted Digital Info, Trunk Video and Unrestricted Multirate are not
used and should remain disabled. See
Possible values: Enable or Disable (default)
The method used for selecting an idle 'B' channel and the reaction if the PSTN
indicates the channel is not available needs to be chosen to originate a call from
CTX.
Possible values: Explicit (default), Preferred or Any Channel
Preferred option is recommended, unless PSTN needs other choice.
The search method for choosing an idle 'B' channel shall also be specified.
Backward Terminal is the normal method with the PSTN following a Forward
Terminal method.
Possible values: Forward Cyclic, Backward Cyclic, Forward Terminal or
Backward Terminal (default)
1544 Time Slot Pattern.
Possible values: Fixed1 (default), Flexible or Floating
2048 Time Slot Pattern
Possible values: Fixed1 (default), Fixed2 or Flexible
Specify whether the T-Wait timer is to be enabled or disabled. This field is only
valid for Nat'l ISDN. This should not be enabled for PRI, it is for BRI.
Possible values: Enable or Disable (default)
Enable Ringback Tone when terminating a call. This field is only valid for Nat'l
ISDN.
Possible values: Enable or Disable (default)
Set this span as Master or Slave for Layer 2 of a QSIG PRI. The opposite value
must be set for the node in which this QSIG PRI terminates. This governs call
setup activity and is not related to clock synchronization.
Possible values: Master (default) or Slave
Sets this span as Side A or Side B for Layer 3 of a QSIG PRI. The opposite value
must be set for the node in which this QSIG PRI terminates.
Possible values: Side A (default) or Side B
Enable this option to allow 2-B channel conference on PRI calls. This allows to PRI
channels to be connected in the same conference or Tandem call.
Note This option must also be enabled by PRI provider to allow it to work.
Table 6-8.
Trunks
ISDN
6-27