Toshiba Strata CTX Programming Manual page 101

F
IELD
03 Key Strip Type
04 Add on Modules
05 Tone First /Voice
First
06 OCA Type
09 Handsfree MIC
Setting
10 Handsfree Tone
11 Ext. Ring Repeat
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
D
ESCRIPTION
Select the number of feature buttons to assign to this station.
Note Although the scroll down menu enables you to choose any value from
1~24, valid values are 10, 14 and 20.
Possible values: 1, 3, 10, 14 or 20 (default)
Select the number of Add On Modules (ADM) assigned to this station. This field is
required if you want to program ADM FBs in Program 213. See
Possible values: None (default), 1 unit, or 2 units
Set PDN to have Tone First or Voice First signaling when called.
For each iES32 PDN, set to "Tone First", if set to Voice First iES32 will not answer.
Possible values: Tone or Voice (default)
Select the OCA type. This field must be programmed with Auto OCA Originate
below.
Possible values: Handset (default) or Speaker
If you call a station configured for Voice First signalling, you can use this parameter
to enable the called parties microphone from your DKT.
Possible values: Enable (default) or Disable
If you call a DKT configured for Voice First signalling, you can use this parameter to
send a splash tone to the called party.
Possible values: Enable (default) or Disable
Enable repetitive ringing for incoming CO / PBX / Centrex signals. Disabling this
parameter defaults to standard CO ringing pattern (1 sec on / 3 sec Off).
Possible values: Enable or Disable (default)
Station
Assignment
"Key" on page 5-16.
5-9