Voice Packet Configuration Table Assignment - Toshiba Strata CTX Programming Manual

152 Voice Packet Configuration Table Assignment

This Program Assigns timing parameters to Prime DNS.
1. From the Program Menu,
click IP-Telephone > Voice
Packet Configuration. The
Voice Packet
Configuration Table
Assignment screen
displays (shown right)
2. Enter Program 152 data.
3. Click Submit.
F
IELD
Voice Packet Table
Number
01 Voice Packet Trans. Int.
02 Jitter Buffer Type
03 Jitter Buffer Length
04 Max. Acceptable Delay
05 Measurement Period
06 Packet Loss Ratio
07 Packet Loss Threshold
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
D
ESCRIPTION
Enter the Voice Packet Configuration Table Number(1-256)
Possible values: 1~128 (CTX100 & CTX670 Basic)
1~256 (CTX670 Exp.)
Voice Packet Transmission Interval:
This depends on the encoding method G711 or G729A. The default setting
are G711: 20ms, G729A: 40ms. 10ms is only used to test. So don't use
10ms.
If LAN bandwidth is not enough for these parameters and the problem is
resolved to extend the interval according to the LAN requirement, you can
change to G711:40ms and G729a: 80ms. Note: 30ms need not be used.
Possible values: 10 msec (available for testing only up to release
200MF008), 20 msec (default), 30 msec, 40 msec or
80 msec
You can leave this field with its default or you can change the jitter buffer
type of DSP on BIPU.
Possible values: Fixed, Sequential, or Adaptive (default)
You can leave this field with its default or you can change the jitter buffer
lenght of DSP on BIPU.
Possible values: 0~250
Not available in Release 2.0.
Not available in Release 2.0.
Not available in Release 2.0.
If packet loss is more than 10, an error is recorded in the CTX error log and
you cannot talk by IPT.
Possible values: 0~10
IP Telephone Programming
152 Voice Packet Configuration Table Assignment
6719
8-5