Event Trace Control; Start/Stop Trace - Toshiba Strata CTX Programming Manual

Event Trace Control

Programs Used: 903, 904, 905 and 906
Prerequisite Program:
This program enables you to trace message events occurring in Strata CTX. Program Numbers 903, 904,
905 and 906 are consolidated in one CTX WinAdmin screen (shown below).
1. Install the SmartMedia Card into the
designated slot of the Strata CTX
processor.
2. From the Program Menu, click
Maintenance > Event Trace Control.
3. Enter Program 903 data.
4. Enter Program 904 data
5. Enter Program 905 data.
6. Enter Program 906 data.
7. Trace data displays in the dialog
boxes.

903 Start/Stop Trace

F
IELD
Start/Stop Trace
Size
Category
904 ISDN Trace Location
ISDN protocol event trace collection conditions are established using this program.
This trace can be performed on BSU and PTU cards only.
Note
F
IELD
Cabinet/Slot/Port
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
None
D
ESCRIPTION
Click in the appropriate button to Start or Stop Message Trace. Start Trace indicates
that the system's trace data collection process has begun. Stop indicates the trace
data collection process is terminated
Before removing the SmartMedia card run Program 908. See
page 10-4.
Possible values: Start Trace or Stop Trace (default)
Set the trace data size. Toshiba recommends leaving this parameter at the default
setting which provides approximately 15 minutes of trace data.
Possible values: 1~256 bytes with 1 unit = 16 bytes (default = 2)
Select Trace data type to be stored.
Possible values: Call Processing, Maintenance, and Call Processing and
Maintenance (default)
D
ESCRIPTION
Enter the Equipment Location to be traced (xxyyzz).
Possible values: xx = Cabinet 01~07; yy = Slot 01~10; zz = Circuit 01~04
Maintenance
Event Trace Control
"908 SmartMedia" on
11-3