Toshiba Strata CTX Programming Manual page 424

System Error Codes
Trunk Programming Error Codes
Program Code
33
49
52
316
54
80
80
33
49
50
52
54
317
80
80
80
80
96
48
49
49
318 80
82
82
96
319 48
B-14
Occurred Sub-
FB parameter
RPTU Equipment Number entered is invalid.
A7
If the Span Interface speed is set to a value not equal to 1.5M,
A7#
the Dch position is modified.
The entered channel group number conflicts with an existing
A7
ISDN extension(s).
The equipment number entered is out of range.
A7
The entered channel group number does not exist in the
A7
system.
The entered circuit must be an assigned ISDN.
A7
The entered equipment value is invalid.
A7
The entered ILG/OLG values do not have ISDN assignments.
A7"
A7#
The T-Wait Timer can only be enabled if the Protocol is set to
A7 '
National ISDN.
The entered channel group number conflicts with an existing
A7
ISDN extension(s).
The quantity of lines, ISDN channels and PDNs entered
A7
exceeds the number of ports licensed with this processor.
The entered channel group number does not exist in the
A7
system.
The entered circuit must be an assigned ISDN.
A7
The entered ILG number does not exist in the system.
A7"
The entered OLG number does not exist in the system.
A7#
The allowable channel group assignments exceed the system
A7
capacity.
No incoming destination number is assigned for the required
A7$×
parameter.
A7 
The selected GCO conflicts with an existing ILG number.
A7"
The selected Pool Line Group conflicts with an existing ILG
A7#
number.
The entered GCO key group does not exist in the system.
A7"
The selected ILG number does not exist in the system.
A7
The selected ILG number does not exist in the system. The
A7
number of ILGs exceed the system capacity.
The number of allowable GCO or POOL key group
A7"
assignments has been exceeded.
A7#
The destination number is not assigned.
A7 —A7"
Error Descriptions
Strata CTX Programming - Part 4: Appendices 04/03