Step 1: Use Default Auto-Programming To Start Up - Toshiba Strata CTX Programming Manual

Strata CTX Programming Guidelines
This chapter discusses Strata CTX programming basics and guides you through initial setup procedures. It
also describes auto-recognition features, order of programming, and overview of general CTX WinAdmin
and Button Programming operations. Programming sequence tables are provided to streamline your
programming tasks.
Step 1: Use Default Auto-programming to
Start Up
This feature reduces the programming time to install Strata CTX systems. The Strata CTX system will
automatically program specific default data in a number of programs based on the PCBs that are installed
in the system before processor initialization. The default data and procedure for auto-programming is
provided in this section.
1. Install all line, station and optional PCBs that should be recognized for auto programming.
2. Power-on the system and initialize auto-programming for the system (Program 900, Level 1).
3. Verify "Station and BIOU Auto-programming"
4. Verify "Station PDN Auto-programming"
5. Verify "CO Line Auto-programming"
6. Verify "CTX Processor NIC Interface TCP/IP Auto-programming"
Notes
•
The type of PCB, its cabinet and slot position are automatically recognized upon system initialization;
or, when powering the CTX processor for the first time.
•
Each installed PCB circuit equipment number is set in numerical order based on the cabinet and slot
position of the PCB.
•
Station Primary Directory Numbers (PDN) and CO line numbers are set in numerical order according
to their equipment cabinet/slot positions.
•
Other default data, such as the Strata CTX LAN and modem interface IP address, station and line class
of service, outgoing and incoming line groups, etc., are automatically set for the optional hardware
originally installed.
Strata CTX Programming - Part 1: Getting Started 04/03
on page 1-2.
on page 1-3.
on page 1-3.
on page 1-7.
1
1-1