Chapter 4 - Rwiu System Installation Step 1: Check Dip Switches And Jumpers On Pcb - Toshiba Strata AirLink Installation Manual

RWIU System Installation
This chapter describes the specific installation steps for the RWIU PCB.
Step 1: Check DIP Switches and Jumpers on PCB
The RWIU and WWIS come from the factory already assembled. Remove the
CAUTION!
WWIS carefully to check the DIP switches on the RWIU, keeping the pins on it
straight. After checking the DIP switches, but before aligning the two PCBs, be
sure that the connectors are not bent. This causes irreparable damage to both
PCBs.
The RWIU has three DIP switches. The location of each is shown in
positions are given in the following steps.
S3
J13
J12
J8
Figure 23 Location of RWIU DIP Switches S1~S3
Strata AirLink Installation Guide
S2
J17 J16
J15 J14
RWIU (top view)
J10
LD2
5/00
Figure
J13
JTAG
J9
J7
4
23. The factory default
S1
LD1
3513
43