Toshiba Strata CTX Programming Manual page 203

Tables
Strata CTX uses two or three tables to apply DR:
Screening Tables. There are two types of screening tables as follows:
•
• LCR Screening Tables.
• OLG-Specific Screening Tables.
DR Table or Exception Table to the DR Table.
•
Screening tables are used in Behind Centrex/PBX operations to detect access codes required by the
Centrex/PBX and processes them appropriately in a way that is transparent to end users.
DR/LCR Screening
DR is applied to all LCR calls using
the digits dialed after the LCR access code (typically
Example: A station user dials
that this user is attempting to forward to his home. The System Administrator has created an LCR/
Screening entry to prevent the forwarding of this line to the users home. With Skip & Apply under DR
action and a Skip Length of 0, the call will be forced to present
rejected. Apply under LCR Action ensures that the entire string will be processed by LCR. In this case,
Digit Modification is irrelevant.
DR Screening for OLG Table
An OLG-specific DR Screening Table is used when a call is originated through a Line Key, Pooled Line
Key, Group CO Key, Trunk Group Access Code or Direct Trunk Access Code and a CO line is chosen that
requires DR. The decision to apply DR to an OLG is made in
the OLG does not require DR, the call is connected to the desired line and all dialed digits, minus the Strata
CTX access code, are sent.
The OLG-specific table performs two functions:
It manipulates the digits that will be screened by the DR table.
•
It creates a Pause Value that ensures that the Centrex or PBX which is the source of the trunk will
•
receive and interpret the digits correctly. This is used to compensate for older, slower equipment.
Example: A station user dials 81-9-1-617-234-5678 where 81 is the Trunk Group Access Code for a
Centrex trunk group. 9 is the Centrex' LCR access code. The Skip Length of 1 tells the system how many
of the first digits constitute an access code or other digits that may be ignored. The DR Action of Skip &
Apply tells the system to ignore the 9 and present 16172345678 to the DR Table use in the next step in the
process. The Pause Value of two seconds tells the system that, if it passes the DR Tables and is connected
to a trunk, it is to pause two seconds after outdialing the 9 and before outdialing 16172345678.
Dial String
9
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
"530 DR LCR Screening Table Assignment"
   
- - -
DR Action Skip Length
Skip & Apply
Least Cost Routing/Destination Restriction
).

. The outgoing line will serve as an incoming line

to the DR table where the call will be
"306 Outgoing Line Groups"
Pause Value
1 2
Services
on page 9-19. It analyzes
on page 6-4. If
9-17