Toshiba Strata CTX Programming Manual page 421

Trunk Programming Error Codes
Program Code
33
49
49
49
300
49
54
80
80
80
96
96
301 6
33
48
49
49
50
52
302
54
80
80
80
80
Strata CTX Programming - Part 4: Appendices 04/03
Occurred Sub-
FB parameter
The equipment number entered is out of the range.
A7
When modifying previously assigned equipment:
•
A7
•
The ISDN ILG number is designated for analog trunks or the
A7!
entered ILG number does not exist in the system.
The ISDN OLG number is designated for analog trunks or the
A7"
entered OLG number does not exist in the system.
A conflict exists between the ILG number and the OLG
A7!
number trunk type.
A7"
The quantity of lines, ISDN channels and PDNs entered
A7
exceeds the number of ports licensed with this processor.
A trunk number that does not exist in the system has been
A7
selected.
The entered ILG number does not exist in the system.
A7!
The entered OLG number does not exist in the system.
A7"
Allowable number of trunks has been exceeded.
A7
The line number entered exceeds the system's capacity.
A7
A trunk number that does not exist in the system has been
A7
selected.
The equipment number entered is out of the range.
A7
Dch position is not set to 16. When setting the time slot
A7&
pattern for a 2048 kbps interface, this value must be set to 16.
The type of ILG or OLG entered in not an ISDN.
A7"
The ILG or OLG entered does not exist in the system.
A7#
The T-Wait Timer can only be enabled if the Protocol is set to
A7!#
National ISDN.
The entered Channel Group conflicts with an existing ISDN
A7
extension(s), etc.
The quantity of lines, ISDN channels and PDNs entered
A7
exceeds the number of ports licensed with this processor.
The entered Channel Group number does not exist in the
A7
system.
An ISDN trunk cannot be assigned to the designated Shelf/
A7
Slot/Circuit.
The designated ILG does not exist in the system.
A7"
The designated OLG does not exist in the system.
A7#
Error Descriptions
The designated PCB Type does not allow CO trunk
assignments.
The designated circuit does not allow CO trunk
assignments.
System Error Codes
Trunk Programming Error Codes
B-11