Toshiba Strata CTX Programming Manual page 376

Telephone Button Programming
900 Series Programs
FB Name
Trace State
Trace Size
Trace Category
)%
1. Press
+ROG
2. Press
Notes
Start indicates the trace was previously started and is currently running.
G
Stop indicates the trace is not running and all trace buffer data was transferred to SmartMedia.
G
)%
3. Press
+ROG
4. Press
)%
5. Press
+ROG
6. Press
7. Enter another program number to continue programming or press
mode.
When CTX 670 stops logging data, it automatically sends data to the SmartMedia card. A new trace
Note
file is stored on SmartMedia under the Evnttrace directory. Run the Unmount command (Program
908) before removing the SmartMedia card to ensure complete data transfer.
13-98
FB
Enter  or  to Start or Stop Message
01
Trace. Stopping the trace outputs data to
the SmartMedia card. Wait for the
prompt on the LCD before proceeding.
Before removing the SmartMedia card run
Program 908. See
SmartMedia" on
02 Set the trace data size. Toshiba
recommends leaving this parameter at the
default setting which provides
approximately 15 minutes of trace data.
03
Trace data type to be stored.
to enable Start or Stop trace. Use the number key pad to make your selection.
.
to enter trace file size. To change the setting, use the number Dial Pad.
.
to set trace category. To view setting options, press the
twice to execute. Wait for the
Summary
352*
"Format/Unmount
page 13-101.
= prompt to display before proceeding.
PROG
Strata CTX Programming - Part 3:Telephone Button Programming 04/03
Value LCD Prompt
1:Start 1:START
2:Stop 2:STOP
1~256 (in bytes) SIZE=
1 unit = 16 bytes.
default = 2
1:Call Processing 1.CP
2:Maint and Admin 2.M&A
3:Both of the above 3.CP+M&A (default)
6FUROO 3DJH
or button.
+ROG
again to exit programming