Toshiba Strata CTX Programming Manual page 156

Trunks
ISDN
F
IELD
14 Initialize Type
15 Initialization Display
16 SPID #1
17 SPID #2
18 T-Wait Timer
19 Voice Calls
20 Trunk Subscriber 1
21 Trunk Subscriber 2
Table 6-7 Bearer Capability Table
Circuit Mode
6-24
D
ESCRIPTION
Enter the Service Profile Identifier (SPID) type of initialization.
Possible values: User Entry (Auto SPID On), User Entry (Auto SPID Off), Auto
Enter the text to be displayed for SPID Initialization.
Possible values: Up to 4 ASCII characters (default = User)
Enter the SPID value. These fields are required if you selected National ISDN in
Protocol. When no data is entered, any previously entered information is
overwritten.
Possible values: Up to 20 ASCII characters (default = No Value)
Enable the T-Wait Timer. This field is needed if you selected National ISDN in
Protocol above. This timer, used along with the SPID, assigns random initializing
SPID times to prevent BRI interfaces from re-initialize at the same time after a
reset or power outage.
Possible values: Enable or Disable (default)
Select the number of simultaneous voice (speech) calls that can exist at the same
time on this interface.
Possible values: One or Two (default)
Enter the telephone number for subscriber 1. Telephone number should be
consistent with D channel data. If no data is entered in this field any previously
programmed information is lost.
Possible values: Up to 10 digits (default = no value)
Enter the telephone number for subscriber number 2. If no data is entered in this
field any previously programmed information is lost.
Possible values: Up to 10 digits (default = no value)
Bearer Services
Speech
3.1 KHz
7 KHz
64 Kbps
Rate adaptation
from 56 Kbps
Unrestricted
Digital
Information
2x64 Kbps
SPID or None (default)
Bellcore
National ISDN
X
X
X
X
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
ETSI TTC
X X
X X
X X
X X
X X