Dkt Parameters - Toshiba Strata CTX Programming Manual

Station
Assignment

204 DKT Parameters

Prerequisite Program:
This command is used to set up DKT digital telephones station parameters.
1. Use the "DKT Parameters Record Sheet"
2. From the Program Menu, click
Station > Assignment.
3. Click on the DKT tab (shown
right).
4. Enter a DN number in the
Primary DN field
...or click one of the following
buttons:
• List – view a summary list of
programmed DKTs.
• PDN Table View – view a
detailed list of programmed
PDNs.
• Selective Copy – Enable you
to copy some or all of the
parameters to the destination PDNs.
5. Setup the DKT by adding values to the remaining fields.
6. Click Submit.
F
IELD
01 Station Type
02 Key Strip Pattern
5-8
200 on page 5-1
on
D
ESCRIPTION
Select the Station Type. When set to Attendant, the system can support four
circuits.
Possible values: Extension (default) or Attendant
This option allows you select a pre-defined keystrip pattern and submit it to the
digital telephone. It does not display what pre-defined keystrip (if any) has been
assigned to the telephone.
Use the Key tab screen to view or edit telephone keystrip assignments.
CAUTION! Submitting a keystrip pattern will overwrite existing keys
programmed on a telephone.
Default key strip patterns for digital telephones. The selected Pattern is applied to
the 'Key Strip Type' parameter.
None – applies PDN to button 01 and blank to all other buttons.
Pattern 1 – applies PDN to button 01, plus line buttons and DND.
Pattern 2 – applies PDN to button 01, plus line buttons, One-Touch buttons and
DND.
Pattern 3 – applies PDN to button 01 and blank to all other buttons. (DKT3014 uses
only Pattern 1 or None).
Possible values: Pattern 1, 2 or None (default)
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
page D-12 to record your desired DKT settings.