Trunk Did/Dnis Setup Wizard - Toshiba Strata CTX Programming Manual

Trunk DID/DNIS Setup Wizard

This wizard enables you to assign Direct Inward Dialing / Dialed Number Identification Service (DID/
DNIS) to ILGs quickly and easily. The wizard automatically takes you through the different programs and
parameters required.
Follow the steps below to start using the DID/DNIS Wizard.
Step 1: Select or Create DID/DNIS ILG
1. Select Trunk > Setup Wizard >
DID/DNIS.
2. After reading the instructions on
the screen (shown right), click
Start.
Step 1: 304 Select or Create DID/
DNIS ILG screen displays (shown
right).
3. In the 00 DID/DNIS Incoming Line
Group (ILG) field, click Create
...or from the drop-down menu,
select a DID/DNIS ILG to edit.
Note Only DID/DNIS ILGs appear in
the drop-down box.
See table below for screen fields
and field descriptions.
F
IELD
01 ILG Type
11 DID/DNIS Digit Length
02 Line Type
03 DID/DIT Service
04 Std/Q-SIG Service
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
D
ESCRIPTION
Select analog for RDDU or RDTU interface, or ISDN for RPTU interface.
Select the number of digits (1~7) that compose each DID number for this
DID/DNIS ILG. This is the number of DID digits sent from the CO on
incoming DID/DNIS. If ANI digits are sent with DID digits, only set this
parameter for the quantity of DID digits sent.
DID lines should always be set as CO type lines.
DID lines should always be set as DID service
DID lines should always be set for "Standard" service
Trunks
Trunk DID/DNIS Setup Wizard
6-35