Toshiba Strata CTX Programming Manual page 339

Programs 303~315
(continued)
Button Sequence
310-04 MOH Source
, n, ,
A7# C‚yq C‚yq
311 DISA Security Codes
,
" C‚yq
311-01 DISA Enabled
, n,
A7 C‚yq
311-02 DISA Code
, n,
A7! C‚yq
311-03 Response Timer
, n,
A7" C‚yq
311-04 Idle Timer
, n,
A7# C‚yqÃC‚yq
313 Caller ID Assignment
,
" " C‚yq
313-00 Trunk Number
n, ,
C‚yq
313-01 Signalling Method
, n,
A7 C‚yq
313-02 Signalling Contents
, n,
A7! C‚yq
313-03 CLASS Equipment
Position
, xxyyzz,
A7" C‚yq
Strata CTX Programming - Part 3:Telephone Button Programming 04/03
Value(s)
n = 1. Silence
2. External 1 (default)
3. External 2
4. External 3
5. External 4
6. External 5
7. External 6
8. External 7
9. External 8
10. External 9
11. External 10
12. External 11
13. External 12
14. External 13
15. External 14
16. External 15
n = 1. Enable
2. Disable (default)
n = Up to 15 digits
n = 0~30
(default = 5)
n = 0~60
(default = 10)
n = 1~64 (CTX100)
1~96 (CTX670 Basic)
1~264 (CTX670 Exp.)
n = 1. None (default)
2. ANI/DNIS-MCI
3. ANI/DNIS-Sprint
4. CLASS (Caller ID)
n = 1. ANI and DNIS (default)
2. ANI only
3. DNIS only
4. DID only
xx = Cabinet 01 (CTX100),
01~02 (CTX670 Basic),
01~07 (CTX670 Exp.)
yy = Slot 01~8 (CTX100),
01~10 (CTX670)
zz = Circuit 01~08
Telephone Button Programming
Summary
Select the MOH source for Analog DIT Trunk. The Scroll key must be
used to select MOH sources indicated by 10 or higher.
This command assigns DISA parameters.
Enable DISA security code.
Enter DISA security code.
Enter the time, in seconds, for Strata CTX to respond to a call.
Enter the time in seconds to wait for idle DTMF.
This program assigns Caller ID circuits to the CO Line to which the
circuit is connected. The ANI, DNIS, DID formats for TI and analog
DID CO Lines are also defined.
Enter the Trunk Number.
Specify the format for the interface being used.
Specify the contents of the ANI/DNIS format.
If the CLASS type is chosen, the trunk must be assigned to a Caller
ID circuit. Enter the RCIU/RCIS equipment number as xxyyzz.
Notes
• CLASS equipment numbers are required when assigning a trunk
to a RCIU/RCIS circuit.
•
It can also be used to display the equipment location of existing
caller ID circuit to trunk assignments. Example: If the trunk should
be connected to a caller ID circuit (RCIU/RCIS) in cabinet shelf 5,
slot 2, circuit 3, enter 050203.
300 Series Programs
13-61