Programs 203~204
Button
Sequence
203
Change DN
,
!"
Cyq
203-00
Primary DN
n,
Cyq
203-01
Enter new DN
, n1,
,
A7
Cyq
Cyq
204
DKT Parameters
,
!#
Cyq
204-00
Primary DN
n,
Cyq
204-01
Station Type
, n,
A7
Cyq
204-02
Key Strip Pattern
, n,
A7!
Cyq
204-03
Key Strip Type
, n,
A7"
Cyq
204-04
Add on Modules
, n,
A7#
Cyq
204-05
Tone 1st /Voice 1st
, n,
A7$
Cyq
204-06
OCA Type
, n,
A7%
Cyq
204-09
Handsfree MIC
Setting
, n,
A7(
Cyq
204-10
Handsfree Tone
, n,
A7
Cyq
204-11
Ext. Ring Repeat
, n,
A7
Cyq
Strata CTX Programming - Part 3:Telephone Button Programming 04/03
Value(s)
n =
Up to 5 digits
n1 =
Up to 5 digits
n =
Up to 5 digits
n =
1. Extension
2. Attendant
n =
1. Pattern1
2. Pattern2
3. Pattern3
4. None
n =
1~24
n =
1. None
2. One Unit
3. Two Units
n =
1. Tone
2. Voice
n =
1. Handset
2. Speaker
n =
1. Enable
2. Disable
n =
1. Enable
2. Disable
n =
1. Enable
2. Disable
Telephone Button Programming
Summary
This command changes DN.
Enter DN to change.
Enter new DN.
This command assigns DKT digital telephone data.
Primary DN
For CTX R1 this must be set to "Extension." The "Attendant" option is
not available for this release.
Default key strip patterns for digital telephones. The selected Pattern
is applied to the "Key Strip Type" parameter (DKT3014 uses only
Pattern 1 or None).
•
None - applies PDN to button 01 and blank to all other buttons.
•
Pattern 1 - applies PDN to button 01, plus line buttons and DND.
•
Pattern 2 - applies PDN to button 01, plus line buttons, One-
Touch buttons and DND.
•
Pattern 3 - applies PDN to button 01 and blank to all other
buttons.
Apply 1, 3, 10, 14, or 20 button keystrip type to digital telephones.
•
1 and 3 button keystrips apply to DKT2001 and DKT3001.
•
10 button keystrips apply to DKT2010 and DKT3010.
•
14 button keystrips apply to the Large LCD DKT3014
•
20 button keystrips apply to DKT2020 and DKT3020.
The Number of Add-on Modules assigned to this station.
Set PDN to have Tone First or Voice First signaling when called.
For each iES32 PDN, set to "Tone First", if set to Voice First iES32 will
not answer.
Select the OCA type. This field must be programmed with Auto OCA
Originate below.
If you call a station configured for Voice First signalling, you can use
this parameter to enable the called parties microphone from your
DKT.
If you call a DKT configured for Voice First signalling, you can use this
parameter to send a splash tone to the called party.
Enable repetitive ringing for incoming CO/PBX/Centrex signals.
Disabling this parameter defaults to standard CO ringing pattern
(1 second on/3 seconds Off).
200 Series Programs
13-33