Toshiba Strata CTX Programming Manual page 237

F
IELD
02 BIOU Relay Number
03 DDCB Equipment No.
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
D
ESCRIPTION
Assign BIOU control relay as a Door Lock Relay. This relay activates when the
Door Lock button is pressed or a Door Lock access code is dialed.
Possible values: 0~8 (default = 0)
BIOU1 provides control relays 1~4
BIOU2 provides control relays 5~8.
Note The CTX100 ACTU built-in relay is programmed as relay 5. For this
relay operation BIOU2 is installed as default in a virtual equipment
position Cabinet 2, Slot 5, PCB code 20, in Program 100. To install an
actual BIOU2 and disable the ACTU built-in relay, use the programming
telephone to remove the virtual BIOU2 and then install the actual BIOU2
in Cabinet 01/slot 01~08 in the normal manner. BIOU relay functions are
assigned in "515 View BIOU Control Relay Assignments"
This field is required if you selected BIOU in 01 Interface Type above.
Enter the DDCB equipment number to which the Door Lock should be assigned.
This is the cabinet, slot, and circuit number of the BDKU/BDKS or PDKU
interface PCB to which the DDCB is to be connected.
Possible values: xx = Cabinet 01 (CTX100), 01~02 (CTX670 Basic),
01~07 (CTX670 Exp.)
yy = Slot 01~08 (CTX100), 01~10 (CTX670);
zz = Circuit 01~16 (default = no value)
Example: If the DDCB interface should be connected to a PDKU or BDKU/BDKS
in cabinet shelf 5, slot 2, circuit 3, enter 050203.
Notes
This is the cabinet, slot, and circuit number of the BDKU/BDKS or PDKU
•
interface PCB to which the DDCB is to be connected.
If a PDN is assigned to the DDCB equipment number it must be deleted,
•
using PRG201, before attempting to assign the DDCB console.
Services
External Devices
on page 9-52.
9-51