Toshiba Strata CTX Programming Manual page 170

Trunks
Trunk DID/DNIS Setup Wizard
F
IELD
Destination Type
Set the Dialing Digits
range
6-38
D
ESCRIPTION
Select the type of destination:
DISA - to call in and receive DISA dial tone.
Built-in modem - to call in directly to the CTX modem with CTX WinAdmin.
Night Bell - to call in and close the BIOU or ACTU night bell control relay.
Dialing Digits - to call in and:
•
Ring PDNs, PhDNs, and/or Pilot Numbers
•
Night Ring over External Page - feature access code must be included in
the dialing digits.
• Access outgoing CO lines, Network Nodes and/or LCR to set up tandem
calls - line access codes must be included in the dialing digits.
Notes
• When Dialing Digits is the selected Destination Type, you must set the
Dialing Digit Range below.
• This selection will override any GCO or Pool Key Group assignment
made in this Program or Program 304, ILG assignments.
Select the method in which dialing digit ringing destinations should be
created:
Use DNIS as Destination - the destination digits for each DID/DNIS number
will be the same as the DID/DNIS number. This option is normally used
when the DID/DNIS numbers match the telephone PDNs, PhDNs etc.
Start with - enter the number to which the first selected DID/DNIS number
should ring. Ringing destinations will be assigned consecutively, starting
with this number, to each consecutive DID/DNIS number.
Only Use - all selected DID/DNIS numbers will be assigned to the dialing
digits entered here.
Add to front - these digits will be added in front of each dialing digit number.
Add to End - these digits will be added to the end of each dialing digit
number.
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03