Telephone Button Programming
100 Series Programs
Programs 103~107
Button
Sequence
104-14
Emergency Call Timer
, n,
A7 #
Cyq Cyq
104-15
ABR Busy Detection
Time
, n,
A7 $
Cyq Cyq
104-16
Lost Call Timer
, n,
A7 %
Cyq Cyq
104-17
Lost Call Final Timer
, n,
A7 &
Cyq Cyq
104-18
DTMF Tone Sending
Time
, n,
A7 '
Cyq Cyq
104-19
Auto Disconnect
, n,
A7 (
Cyq Cyq
105
System Parameters
,
$
Cyq
105-01
Executive Override
, n,
,
A7
Cyq
105-02
Station MOH
, n,
,
A7!
Cyq
105-03
Ringing Transfer
, n,
,
A7"
Cyq
105-04
Transfer Privacy
, n,
,
A7#
Cyq
105-05
Privacy Override
, n,
,
A7$
Cyq
105-06
Credit Card Code
, n,
,
A7%
Cyq
13-18
(continued)
Value(s)
n =
10~180 sec.
(default = 30)
n =
1~30 sec.
(default = 5)
n =
1~600 sec.
(default = 180)
n =
1~600 sec.
(default = 180)
n =
1. 80 ms (default)
2. 160 ms
n =
0~60 sec.
(default = 0)
n =
1. Enable (default)
2. Disable
Cyq
n =
1. Quiet Tone
2. External 1 (default)
Cyq
3. External 2
4. External 3
5. External 4
6. External 5
7. External 6
8. External 7
9. External 8
10. External 9
11. External 10
12. External 11
13. External 12
14. External 13
15. External 14
16. External 15
n =
1. RBT (default)
2. MOH
Cyq
n =
1. Enable (default)
2. Disable
Cyq
n =
1. Enable
2. Disable (default)
Cyq
n =
Up to 32 digits
Cyq
The Emergency Call timer sets a time (10 ~ 180 seconds) for
advancing the call to the next station in a list of destinations for the
call.
The Destination Busy Detection timer sets the time (1 ~ 30 seconds)
to wait while looking for a busy condition on an external call. If
detected, it will trigger the initiation of the Automatic Busy Redial
cycle.
The Lost Call timer sets the time (1 ~ 600 seconds) that a failed
transfer recall will ring on the originating station prior to attempting to
recall a secondary location.
The Lost Call Final timer sets the time (1 ~ 600 seconds) that a failed
transfer recall will ring on the secondary location before being
automatically disconnected.
The DTMF tone sending duration (1-80 msecs, 2-160 msecs) for
dialing on CO Lines.
Time after which an unsupervised trunk may be automatically
released.
This command assigns the system parameters.
Break in warning tone of Executive Override Enable or Disable.
Music On Hold selection of Private Line and Station.
Tones for the transferred party after the ringing transfer takes place.
Transfer Privacy enabled: CO line buttons that have multiple
appearances will only flash and ring on the transferred-to telephone;
the same CO line button on other telephones will be red-busy.
Transfer Privacy Disabled: CO line buttons that have multiple
appearances will flash and ring on all telephones that have the CO
line button appearance.
Privacy Override Attendant Monitor warning Enable or Disable.
Enter the number dialed to initiate a Credit Card Call. This is normally
"0" in the USA.
Strata CTX Programming - Part 3:Telephone Button Programming 04/03
Summary