System Communication; Report Code Format - ADEMCO Via 30+ Installation Instructions Manual

SYSTEM COMMUNICATION
Report Code Formats The Report Codes for Alarm, System Status, and Restore for
Zones shown in program fields *56-*75 can be selected in field *46
to report to the central station in any of the following formats:
Note: If OUTPUT TO LONG RANGE RADIO (field *27) is enabled, all dialer and
long range radio reports will be sent in Contact ID format (see next page),
regardless of the selection made in field *46.
The 3+1 and 4+1 Standard formats comprise a 3 (or 4) digit subscriber
number and a single digit report code (e.g. Alarm, Trouble, Restore, Open,
Close).
The 3+1 and 4+1 Expanded formats comprise a 3 (or 4) digit subscriber
number, and a single digit report code, followed by a second line where the report
code is repeated 3 (or 4) times and followed by another number (normally the
zone number) or user ID related to that report.
The 4+2 formats comprise either a 4 digit subscriber number and two digit
report code, or a 4 digit subscriber number and single digit report code,
immediately followed by the zone number (normally) or user ID.
3+1,
4+1
Report Standard Expanded
Alarm SSS(S) A SSS(S) A SSSS AZ
AAA(A) Z
Trouble SSS(S) T SSS(S) T SSSS Tt
TTT(T)t
Bypass SSS(S) B SSS(S) B SSSS Bb
BBB(B) b
AC Loss SSS(S) E SSS(S) E SSSS EAc
EEE(E) Ac
Low Batt SSS(S) L SSS(S) L SSSS LLg
LLL(L) Lg
Open SSS(S) O SSS(S) O SSSS OU
Close SSS(S) C SSSS CU
Section 6.
ccc(
Test
SSS(S) G
SSSS Gg
RaRaRa(Ra)Ac
-30-