Figure - 4, Removing A Tape Drive Assembly Neo 2000 - Overland Storage NEO 2000 Series Instructions Manual

8) Remove all SCSI connections from the drives and controller card.
9) Loosen the captive retainer screws at the top center and lower left of the drive module, see
10) Pull straight back on the drive assembly handle to remove the drive. Some effort will be required to
overcome the initial resistance of unplugging the module from the receiver.
11) Continue to slide the drive out while fully supporting the module until the drive load handle (DLT 8000
only) has cleared the back of the library.
12) Repeat Steps 8 through 10 for each installed drive assembly.
CAUTION:
The power supply is NOT to be removed by the operator. Hazardous voltage is present in the cavity if
the power cord is not removed.
VORSICHT:
Die Stromversorgungseinheit darf nicht vom Bedienungspersonal entfernt werden. Gefährliche
Stromspannung tritt im Hohlraum auf, wenn das Netzkabel nicht entfernt ist.
13) Remove the two mounting screws securing the power supply locking bracket, see
14) Push down on the latch and use the handle to pull the power supply out of the receiver.
Install The XchangeNOW Tabletop Library
1) Attach the four feet removed from the faulty unit to the XchangeNOW® unit and replace
the top cover, see
Figure 4. Removing a Tape Drive Assembly NEO 2000
Figure 5.
Neo-9047
Figure 12.
NEO 2000
Figure 4.
3