Advertisement
NEOxl/Expansion Spare Chassis Replacement
Install the Tape Drive
1. While supporting the drive assembly, slowly insert and
align the tape drive into the same drive bay location it
used in the old chassis.
The tape drive should be flush with the back panel of the
device.
2. Finger-tighten the captive thumbscrews until the tape
drive is secure.
3. To install additional tape drives, repeat
Install the Drive Power Board
1. If used, position the drive power board onto the
alignment rails of the new chassis.
2. Slide the drive power board into the library until seated
firmly.
3. Push the latch up until it snaps into place.
When the drive power board is installed correctly, the
latch will not be loose.
4. Repeat
Steps 1–3
to install any other drive power boards.
Install the Fan Assembly
1. Align the tabs on the new library with the slots at the top
of the chassis fan assembly.
2. Push in the fan assembly until it is flush with the back
panel of the library.
3. Finger-tighten the blue captive thumbscrews to secure
the assembly to the library.
Install the Magazine
1. Pull the magazine back out until fully extended.
2. Load the tape cartridges into the new magazine in the
same location they were in previously.
3. Push the magazine handle slowly until the magazine
release latch snaps into place. The magazine locks into
place after it is correctly installed.
10400661-001
Steps
1–2.
©2015 Overland Storage, Inc.
Page 6 of 8
Advertisement
