Table of Contents
Advertisement
Expansion cards and backup units
9.4.3.2
Removing the defective SAS RAID controller
"Removing the SAS RAID controller" on page 193
Ê
Ê If the RAID card holder on the defective controller is to be reused, remove it
from the board as described in section
on page
190.
9.4.3.3
Installing the new SAS RAID controller
Ê If applicable, install the RAID card holder on the new SAS RAID controller
as described in section
"Installing the SAS RAID controller" on page 190
Ê
9.4.3.4
Connecting cables to the expansion card
Ê Connect SAS cables to the SAS RAID controller.
I
For a complete cabling overview, please refer to section
cables" on page
9.4.3.5
Connecting a backup unit to the expansion card
Ê If applicable, connect a BBU or FBU to the expansion card as described in
sections
"Installing a BBU" on page 209
9.4.3.6
Concluding steps
"Reassembling" on page 63
Ê
"Connecting the server to the power source" on page 69
Ê
"Switching on the server" on page 71
Ê
Ê In order to configure an expansion card that has been installed or replaced,
the card's Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section
page
85.
"Enabling SVOM boot watchdog functionality" on page 89
Ê
"Enabling BitLocker functionality" on page 95
Ê
"Updating RAID controller firmware" on page 84
Ê
196
"Preparing the SAS RAID controller" on page
465.
Upgrade and Maintenance Manual
"Preparing the SAS RAID controller"
or
"Installing a FBU" on page
"Enabling Option ROM scan" on
190.
"List of used
221.
RX300 S8
Advertisement
Table of Contents
