Removing The Defective Sas Raid Controller - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

9.5.4.2

Removing the defective SAS RAID controller

Ê Remove the defective SAS RAID controller as described in section
"Removing the SAS RAID controller" on page
Ê If the RAID card holder on the defective controller is to be reused, remove it
from the board as described in section
on page 427.
9.5.4.3 Installing the new SAS RAID controller
Ê If applicable, install the RAID card holder on the new SAS RAID controller
as described in section
Ê Install the new SAS RAID controller as described in section
SAS RAID controller" on page
9.5.4.4 Connecting cables to the expansion card
Ê Connect SAS cables to the SAS RAID controller.
I
For a complete cabling overview, please refer to section
overviews" on page
9.5.4.5 Connecting a backup unit to the expansion card
Ê If applicable, connect a BBU or FBU to the expansion card as described in
sections "Installing a BBU" on page 435
9.5.4.6 Concluding steps
"Installing the system air duct" on page 83
Ê
"Closing the server" on page 98
Ê
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
Ê Reconnect all external cables to the replaced expansion card.
"Connecting the server to the mains" on page 118
Ê
Ê Enable the PCI slot of the replaced expansion card as described in section
"Enabling replaced components in the system BIOS" on page
TX300 S8 / RX350 S8
"Preparing the SAS RAID controller" on page
426.
738.
Upgrade and Maintenance Manual
Expansion cards and backup units
430.
"Preparing the SAS RAID controller"
or "Installing an FBU" on page
427.
"Installing the
"Cabling
440.
147.
433