Using WebView
WebView CLI Commands
The following configuration options can be performed using the CLI. These configuration options are also
available in WebView.
Enabling/Disabling WebView
WebView is enabled on the switch by default. If necessary, use the
WebView. For example:
-> http server
Use the no http server command to disable WebView on the switch. If web management is disabled, you
will not be able to access the switch using WebView. Use the
status.
Enabling/Disabling SSL
Force SSL is disabled by default. Use the
ple:
-> http ssl
Use the no http ssl command to disable Force SSL on the switch. Use the show http command to view
WebView status.
OmniSwitch 6600 Family Switch Management Guide
show http
http ssl
command to enable Force SSL on the switch. For exam-
April 2006
WebView CLI Commands
http server
command to enable
command to view WebView
page 9-3