SCPI Command Reference
SCPI Conformance Information
Codes and Standards
IEEE 488.2 Requirements
GPIB control implements all IEEE 488.2 requirements.
SCPI Requirements
IEEE 488.2/SCPI Syntax and Style
Parameters: Units of Measure and Multipliers
A-2
This power supply conforms to the following international
standards:
IEEE Std. 488.2-1992, "IEEE Standard Codes, Formats, Protocols,
and Common Commands For Use With IEEE Std. 488.1-1987"
IEEE Std. 488.1-1987 "IEEE Standard Digital Interface for
Programmable Instrumentation"
TIA/EIA-232F
Standard Commands for Programmable Instruments (SCPI)
Version 1999.0
The power supply conforms to the following SCPI requirements:
SCPI mandated commands
Questionable Status Register (QSR), Condition, Event, Enable
Operation Status Register (OSR), Condition, Event, Enable
Status Byte Register (SBR)
Standard Event Status Register (SESR)
Refer to IEEE 488.2, section 7.7.3 for the definition of units of
measure. The default units of measure include:
V (Volt - voltage)
A (Ampere - current)
W (Watt - power)
S (seconds - time)
These units are only supported as defaults. To place the unit in the
command will cause an error to be pushed into the error queue.
M370430-01 Rev B