Current Share Sub-Register - Ametek Sorensen XG Operation Manual

Remote Operation

Current SHare Sub-Register

This register shows the state of the current share configuration, which
can either be set through the front panel Current Share Config menu, or
through the SCPI command.
Important:
configured as a controller. Failure to do so will result in unpredictable
operation.
The SCPI command (s) for these instructions are:
[[:]SOURce]:COMBine:CSHare[:MODE]
Table 5-14 OPERation CSHare Status Register
Bit Bit Weight Bit Name
0 1 CONTroller
1 2 SLAVe
5-42
If current sharing is not being used, the unit must be
Description
The power supply is configured to be a Current Share
CONTroller.
The power supply is configured to be a Current Share
Slave.
M370430-01 Rev B