Resetting The Power Supply; Table 3-9 Power Supply - Ametek Sorensen XG Operation Manual

Resetting the Power Supply

The reset is used to clear the parameters to the factory default values.
Soft Reset The soft reset is used to set the parameters (see Table 3-9) to the default
values, but it does not reset the calibration constants
To perform a soft reset:
1.
2.
3.
After executing a reset, the power supply's settings are restored to the
default settings but retain the calibration data. Table 3-9 lists the default
settings.
Table 3-9
Parameter
Address
Data rate (Kbps)
Communication mode
Vout setting
Iout setting
Output
AUX Out
Trigger
Ext. On/Off Polarity
Auto start mode
AUX Auto start mode
OVP
M370430-01 Rev B
Turn the power supply to Off then On.
When the unit is powering on,
output voltage and current displays.
Press the key combination of both OUTPUT ENABLE Main
button and OUTPUT ENABLE Aux button and hold
continuously for 3 seconds in order to execute.
If the flash fail alarm triggers, it is also possible to reset the power
supply. The front panel should display
Once a reset has been triggered, the output voltage display
shows for 1 second.
The model number will be displayed for 1 second and then return
to normal mode.
Power Supply Default Settings
Local Operation
is displayed on the
.
Setting
1
9.6
RS-232
0 V
0 A
Off
Off
Off
Negative
Off
Off
Maximum
3
3-43