Introduction; Setting Up Xg/Xtr 850 Watt Models; Basics - Ametek Sorensen XG Operation Manual

Communications Options

INTRODUCTION

This chapter contains setup and programming information for the
XG/XTR Series power supply for operation through a LAN/Ethernet
connection. Although the MEA option is no longer available,
instructions for 850 Watt models with the MEA option, including
Troubleshooting, are presented here for reference only.I Instructions for
1500 Watt and 1700 Watt models with the MEB option begin on page
6-32.
The information presented here will guide you in making the
connections necessary to control your power supply remotely.

SETTING UP XG/XTR 850 WATT MODELS

This section is intended for network administrators responsible for the
configuration and maintenance of devices on the network. It provides
information for connecting and configuring the power supply with the
MEA option in earlier models.
Important: If using the MEB version of the LAN interface, please refer to the
section on LOCAL AREA NETWORK (LAN) OPTION on page 6-32.

Basics

This section describes the equipment and procedures to fully set up the
simplest configuration of an XG/XTR 850W unit with the ENET option
and a single computer.
Important: The remote interface that was previously configured when the
local lock setting was activated will still be available for remote control while
the front panel is locked.
System Requirements
• Windows XP, Windows 2000, Windows NT4.0 (with service pack
• Internet Explorer 5.01 or later
• 30 MB hard drive space
• 64 MB RAM
Accessories
• Power supply with ENET port
• ENET RJ-45 and RJ-45 STP, Cat 5 cross-cable
• PC
• Installation CD
6-2
6.0a or later), Windows ME, or Windows 98
M370430-01 Rev B