Ethernet/Lan (Enet) Connector (Optional); Multiple Power Supply Connections To Rs-485 Bus; P Ower S Upply C Onnection To Rs-485 B Us - Ametek Sorensen XG Operation Manual

Ethernet/LAN (ENET) Connector (Optional)

The power supply also can be programmed from a remote terminal
using the Ethernet (ENET). If your power supply is configured with the
Ethernet option, set-up instructions differ between the 850 Watt models
and the 1500 and 1700 Watt models.
For the XG/XTR 850 Watt power supply with the MEA option, see
SETTING UP XG/XTR 850 WATT MODELS in Section 6
"Communications Options" of this manual). Note the the MEA option
instructions in the manual are for reference only. The MEA option is no
longer available.
For the XG/XTR 1500 and 1700 Watt power supplies with the MEB
option, see SETTING UP XG/XTR 1500 and 1700 WATT MODELS in
Section 6 "Communications Options" of this manual.
For connecting the power supply to ENET, use a LAN RJ-45 and RJ-45
STP. Use a standard RJ-45 and RJ-45 cross-cable, Cat 5.

Multiple Power Supply Connections to RS-485 Bus

Up to 30 units may be connected to the RS-485 bus. The first unit
(master unit) connects to the controller via any appropriate port, and the
other units (slave units) are connected with the RS-485 bus via the J6
connector. All units connected together should also have unique
multichannel addresses.
A standard straight-through RJ-45 Ethernet network cable can be used to
provide the connection between the power supplies. See Figure 5-13.
IN OUT
Power Supply #1
Figure 5-15 Multi Power Supply Connection to RS-485 Bus
M370430-01 Rev B
IN OUT
Power Supply #2
Remote Operation
IN OUT
Power Supply #30
5-19
5